ONE PAIR OF TWO SMALL NOTCHED PLASTIC LICENSE PLATE COVER SUPPORTS

ONE PAIR OF TWO SMALL NOTCHED PLASTIC LICENSE PLATE COVER SUPPORTS

Plastic support for fixing the license plate cover, sold in pairs. These small supports consist of an adhesive surface and a notch with small transverse joints.

For an order of a batch of more than 50 pairs, you can contact us by email to benefit from a decreasing price.

The principle of use is simple:

1- the support fits onto the plate of your vehicle: thanks to small plastic joints, it can be fixed both on the top and on the bottom of your plate (we recommend hanging at least one pair on the upper part and a pair on the lower part for better hold of your plate cover)

2- you stick your cache on the adhesive surface of the supports

We recommend the use of at least 2 or more pairs of supports for ideal support and centering of your plate cover. First position the brackets on your plate in place, then glue the cover onto the brackets so that they are completely covered. Press without pressing too hard then let the adhesive act for 15 minutes before using your vehicle. You can slide the cover to remove and replace it at any time. Be sure to clean the bonding area of the media before installation.

The lifespan of these supports is almost unlimited when used indoors. If used outdoors, subject to bad weather and dust, the lifespan of these supports is approximately 2 years. This duration is indicative. It depends on many factors. The main thing is to position and glue them correctly initially.

Perfect for fixing your covers during car meetings (obstruction of the plates in the photos), as an advertising item, garage plates, etc.che plaque immatriculation personnalisé / cache plaque immatriculation tuning / système fixation cache plaque / masquer plaque immatriculation